Introduction:
For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.
Advantages:
·Its own hardware interface allows to avoid all compatibility and driver problems;
·Work through built-in 20 or 26 pin JTAG connector;
·Full access to the ECU memory at high speed of more than 100 KB/s;
·Saving files in the open format;
·Firmware checksum verification and recalculation.
·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ
·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known
Supported ECUs:
For TOYOTA DENSO ENGINE CONTROL MODULE based on NEC 7F00XX series MCU :
76F0038
7F0038A
76F0039
76F0039A
76F0040
76F0040A
76F0070 BGA
76F0085 BGA
saving in normal mode without any master-slave.
master only.
auto CHECKSUM CORRECTION support
These processors were introduced at the beginning of CAN support and as a rule with coachwork change.